Notice: We are still working the kinks out on this adapter, so the design may change.
This adapter is designed specifically for the ZeroBreeze Mark III* stock hoses**. The stock hose is "screwed into" this adapter in the same way that the stock hoses are "screwed into" their respective adapter on the ZBM3. Once screwed in, attach the tent adapter to it's respective mate via the notch and grove on the edge, creating a diamond like shape. You then place the adapters on the zippers of the tent and "cinch" the adapter between the double zippers, pulling the tent tight against the adapter.
The adapter is designed in such a way that the outflow adapter can be swapped so that you can either have the ZBM3 inside the tent, pulling the exhaust to/from the outside, or you can have it outside the tent, circulating the air inside. You will need at least one outflow adapter and one inflow adapter for this to work, but you can buy both outflow adapters.
* Not Associated With ZeroBreeze ** IE: https://www.zerobreeze.com/collections/mark-3-accessories/products/front-outlet-duct-of-mark-3
Zero Breeze Mark 3 Tent Adapter
Run your Zero Breeze Mark 3 outside your tent and pass the hoses through the zipper — cool air in, heat and noise out. No cutting, no sewing, no permanent modifications to your tent. The ZBM3 Tent Adapter creates a low-profile, fabric-sealing pass-through using the ZBM3's stock hoses.
Tested with the ZeroBreeze Mark 3 stock hoses. Not affiliated with ZeroBreeze.
Note on tent compatibility: Due to the wide variety of tent designs and zipper styles, we cannot guarantee fit with every tent. Works best with standard horizontal or vertical coil zippers. We recommend checking your zipper profile before ordering.
How It Works
Screw the adapter onto the ZBM3 stock hose (the same way the stock hose attaches to the unit).
Align the adapter with its matching counterpart on the other side of the tent fabric using the notch-and-groove edge — the two halves form a diamond shape when paired.
Feed the hose through your tent zipper, place one adapter half on each side of the fabric, and cinch together.
The tent fabric pulls snug against the adapter, creating an air seal around the zipper.
What You Need
At least one Inflow adapter + one Outflow adapter to run the ZBM3 from outside while cooling inside.
Or two Outflow adapters if you want to run the unit outside and exhaust hot air outward through both ports.
ZeroBreeze Mark 3 stock hoses are required — not compatible with aftermarket flex hose adapters. Available from ZeroBreeze's website.
Compatibility
Tested with: Zero Breeze Mark 3 (ZBM3) stock hoses
Best with: standard coil zipper tents, camping tents, backpacking shelters
Material
Printed in ASA (Acrylonitrile Styrene Acrylate) — rated to 130°F (54°C), UV-resistant, built for long-term outdoor use. Custom colors available — contact us.
